Issue Boot on PXE

  1. last week

    Hello,
    I've issue to boot on PXE (from my surface pro 4).
    It's starting over IPv4 then IPv6 after it's failed and going to reboot (see attached).
    Could you please help me to chack what I made wrong ?

    Thanks in advance.

    Assuming your not using proxydhcp,
    Admin settings->Boot Menu
    Select 4.13.2.x64 from the kernel drop and click create boot files

  2. clonedeploy

    Dec 7 Administrator

    Is secure boot on? If so your pxe mode must be set to grub

  3. Thanks for your quick support.
    it's set to grub and same issue...

  4. Edited last week by jvajoumounien

    I also tried by to set secure boot off and now I've grub>...

  5. clonedeploy

    Dec 7 Administrator

    Are you using a 64bit kernel?

  6. i don't know, how can i check that?

  7. clonedeploy

    Dec 7 Administrator Answer

    Assuming your not using proxydhcp,
    Admin settings->Boot Menu
    Select 4.13.2.x64 from the kernel drop and click create boot files

  8. Super it works now!
    Thanks a lot.

  9. Again me...
    I'm trying to upload an image and i get an error: Could not contact CloneDeploy Server.
    The http link give me true.
    So possible raison will be NIC pilote or issue to obtain an IP.
    How can I add NIC drivers ?

  10. also when I display NIC interfaces I see eth0 (with same MAC address what I enter into CloneDeploy interface).

  11. clonedeploy

    Dec 7 Administrator

    Are you using the dock or a usb nic?

  12. Dock

  13. clonedeploy

    Dec 7 Administrator

    Unfortunately, I've yet to find anyone that has gotten the surface to work with the dock. If you don't have the surface usb nic, the winpe imaging environment is the only other option for the surface.

  14. How can I use "winpe imaging environment" ?

  15. clonedeploy

    Dec 7 Administrator

    http://clonedeploy.org/docs/using-the-winpe-imaging-environment/

  16. OK, Thanks I will try...

  17. Hi,
    I fallowed all steps then when I choose Winpe_efi64 it show "Could Not Copy PXE Binaries".
    Please help.

  18. clonedeploy

    Dec 8 Administrator

    Did you copy the tftpboot folder to the correct location?

  19. It's works now after rebooting the server.
    But upload and dowload the image is too too long (more than 2h for 30Go).
    Any tips ?

  20. 5 days ago

    clonedeploy

    Dec 11 Administrator

    Sorry, I don't have much else to offer. The WinPE environment is slower than linux since it's a file based copy, but that is really slow. A 10 GB image usually takes me around 10 minutes on WinPE. Are you using gibabit equipment?

 

or Sign Up to reply!