I have CloneDeploy 1.3.3 set up.
Long ago I had set up my MacMini to work with it, and it boots into the imaging environment properly.
I haven't used it since then and so I forgot how I got it to work.
Today I tried to do the same with a new device - MacBook Pro.
For starters I added its MAC address to the DHCP's allow list, and was able to get it to net-boot into iPXE, but it failed:
iPXE initialising devices...ok iPXE 1.0.0+ -- Open Source Network Boot Firmware -- http://ipxe.org Features: DNS HTTP HTTPS TFTP EFI Menu Could not open net0: Input/output error (http://ipxe.org/1d6a4a98) Could not open net0: Input/output error (http://ipxe.org/1d6a4a98)
So I followed this guide on the MacbookPro but got stuck at the part where it says "The screen will provide you with information on where to put the NBI..." -- it doesn't provide anything.
I'm not sure what to do now.
Is it possible that I need to change the vendor id in config.ini? If so, how?
I also remember something about id 3913 to load the linux imaging environment, but I can't find much information about this.
Kinda lost, help would be much appreciated.