i have problem with DHCP 66 and 67 option , i have enter my ip adress and pxeboot.0
but the client boot in pxe , receive an ip adress but just after TFTP the client exiting and normal startup Windows
I have in place before Fog server work fine but GPT partition was a problem , so i have just modify the 66 and 67 setting
Do you have an idea ?
Thanks in advance
And very good project , very nice web interface
So it never shows the menu? You may need to change your pxe mode under admin. If it's an EFI machine, you may need to use an ipxe efi boot loader.
i never see the menu ,
i will try this tomorrow. but i have change to legacy boot and same thing
i will keep you informed.
thanks for your help
i have change to admin pxe ipxe_efi64 and click on yes create new boot file and retry but at boot after my dhcp adress TFTP_ blink after ARP Timeout , boot into windows
Difficult to say, I would check firewalls, make sure tftp service is running, verify option 67 is the correct ip, make sure there are no proxy dhcp servers, etc.
nothing like that .
and in the same range fog server was running fine but no gpt support. so i have just change my ip and the image load ( option 66 and 67
Open the tftpd32 gui located at
Select the log view tab
do a pxe boot
attach the output
unless you didn't install on Windows
i'm on ubuntu , i will check for the log and attach
sorry but i don't see any tftp log in /var/log
i have try an telnet to my ip on port 69 but connection refused
i have read and apply the install doc for ubuntu on your site .
for info :
nextgen@sepac-clonedeploy01:~$ sudo status tftpd-hpa
[sudo] password for nextgen:
tftpd-hpa start/running, process 1033
nextgen@sepac-clonedeploy01:~$ ss -anup | grep :69
UNCONN 0 0 *:69 :
so normally service is up
In my experience if the server is listening according to your post, but the connection is refused, it's because something is blocking it. What version of ubuntu are you using? Have you disabled ufw? I believe the log for tftpd-hpa on ubuntu is in syslog
Ubuntu 14.04.04 standard install and i have follow step by step your install process . I have only change the clonedeploy directory to /clonedeploy ( wich is an another raid drive in my server )
by default is ufw enable ?
i have check Status : inactive