Syntax error in cd_pull
Without shrinking the image the upload was successful. Where can I find the log?
I have attached two log files: one with the error, end the other without the error.
I didn't realize you had a log with errors. Should be simple.
Before you upload your image, get in the habit of running
[code]powercfg /H off[/code]
Then you should be able to use a resizable image.
The don't shrink volumes image should work fine too, just can't restore the image to anything smaller than the source drive, but bigger is fine.
ok, thank you. I will try it ...
ok, this helped. Shrinking was successful!
dannyd last edited by
I ran into this problem as well. Is there a way to recover the image that failed the upload? Took me quite a bit to create the image, hate to have to create it all over again. Thank you!
No, I don't know, how to recover the image. I suspect recovering is not possible but I hope I'm wrong. Fortunately I'd made a backup of my image before.
Maybe you'd try this tookit: http://www.ntfs.com/recovery-toolkit.htm
I would try loading a command prompt from the installation media and run chkdsk /r